How is the daily maintenance of the engraving machine?

Daily maintenance of engraving machine. 

The continuous running time is less than 10 hours a day to ensure the cleanliness of the cooling water and the normal operation of the pump, never make the water spindle motor lack of water, and change the cooling water regularly to prevent the water temperature from being too high. 

If the working environment temperature is too low in winter, the water in the water tank can be replaced with antifreeze. 

Every time the machine is in use, pay attention to cleaning, be sure to clean up the dust on the platform and transmission system, and lubricate and lubricate the transmission system (X, Y, Z three axes) regularly (every week). 

(note: X, Y, Z triaxial polished rods are maintained with oil; high-speed butter is added to the screw part; if the working environment temperature is too low in winter, the PRTT ball screw and smooth rod (square or circular guideway) should be washed and cleaned with gasoline first, and then add oil, otherwise it will cause excessive resistance in the transmission part of the machine and lead to machine dislocation. 

)

When carrying out maintenance inspection of electrical appliances, be sure to cut off the power supply until there is no display on the monitor and the power indicator of the main circuit is off. 

After using the engraving machine for about three months, the fasteners should be checked, and the connecting screws on both sides of the gantry, the fastening screws of the screw nuts and the fastening screws of the motors on both sides should be fastened.