What are the requirements of the machining environment of the turning-milling compound NC lathe

The compound CNC lathe of turning and milling is precision mechanical equipment. 

If they are not placed in a reasonable environment, it is easy to damage the body. 

Therefore, the location and use requirements of the machining center must be strictly controlled. 

For more information, please refer to the following points. 

Usually, the machining center is installed in the machining workshop. 

Not only the ambient temperature varies greatly and the use condition is poor, but also there are a lot of mechanical and electrical equipment, which leads to great fluctuation of the power grid. 

Therefore, the installation position of the turning-milling compound CNC lathe requires strict control of the power supply voltage. 

The voltage fluctuation of the power supply must be within the allowable range and remain relatively stable. 

Otherwise, it will affect the normal operation of the NC system of NC turning and milling compound NC lathe. 

The ambient temperature of the turn-milling compound CNC lathe is less than 30 degrees Celsius, and the relative temperature is less than 80%. 

Generally speaking, an exhaust fan or air cooler is installed in the CNC electric control box to keep the working temperature of the electronic components, especially the CPU, constant or the temperature difference small. 

Excessive temperature and humidity can shorten the life of control system components and cause more failures. 

The increase of temperature and humidity and the increase of dust will lead to adhesion on the integrated circuit board and cause short circuit.

When using the turn-milling compound CNC lathe, the user is not allowed to change the parameters set by the manufacturer in the control system at will. 

The parameter setting of these turn-milling compound NC lathes is directly related to the dynamic characteristics of each part of the turn-milling compound NC lathe. 

The value of the gap compensation parameter can only be adjusted according to the actual situation. 

The turning and milling of CNC compound lathe should be far away from the source of vibration, avoid direct sunlight and thermal radiation, and avoid the influence of moisture and air flow. 

If there is a vibration source near the turning-milling compound CNC lathe, an anti-vibration groove should be installed around the turning-milling compound CNC lathe. 

Otherwise, it will directly affect the machining accuracy and stability of the turn-milling CNC lathe, lead to bad contact of electronic parts, cause failure, and affect the reliability of the turn-milling CNC lathe. 

The above is the turning-milling compound CNC lathe, which introduces you to the relevant knowledge of the turning-milling compound CNC lathe in the use environment, while the manufacturer introduces to you the relevant knowledge about the turning-milling compound CNC lathe in the use environment. I hope it will be helpful to you, if you have any other questions, please consult us.