The cause of dimensional instability caused by NC Lathe driver

1.the signal sent by the driver of the CNC lathe is lost, resulting in the driver out of step. 

2.the parameter setting of servo driver of inclined rail CNC lathe is incorrect, and the setting of gain coefficient is unreasonable. 

3.this is due to the interference of the signal sent by the driver and the loss of synchronization. 

4.CNC lathe driver is in a high temperature environment and does not take better heat dissipation measures, resulting in dimensional instability. 

At the same time, this may also lead to changes in the internal parameters of the drive and cause failure. 

5.insufficient driving torque or insufficient motor torque. 

6.The driving current of  driver is insufficient. 

7.Drive damaged

The above is the introduction of the causes of dimensional instability caused by the drive of CNC lathe. 

I hope it will be helpful to all of you. 

To learn more about CNC lathes, please follow us